Cheap PriceList for Gge-10r 1550nm Fiber Optic Equipment - DVI1x2 – GreenGo

FEATURES：

• 1x DVI input and 2xDVI output
• Support resolution:up to 4096×2160@30Hz
• Support for long distance signal transmission
• Installs in minutes, No loss of quality
• Supports wide range voltage DC input (DC5V)

PACKAGE CONTENTS:
1. Main unit   1pcs
2. AC power adapter   1pcs
3. User manual   1pcs
FEATURES OF THE INTERFACE:

FIG.1.0 Rear Panel View

DC5V: DC input
IN: DVI-D input port
OUT 1-4: DVI-D output port
NOTE : EDID MODE: After the splitter is powered on, and then there is a display machine connected to the OUT1, the splitter will get the EDID of display machine connected OUT 1. If there is no any display machine connected to output1, the machine will use default EDID output.

 
FIG.1.0 Front Panel View

Power: Power LED
Signal: Signal LED
OPERATIONG AND CONNECTION:
1.Connect one single link DVI-D cable from a DVI signal source into the input port of splitter.
2.Connect single link DVI-D cables from TV/Monitor into the DVI output ports of splitter.
3.Connect DC plug of AC adapter to DC jack and inserted into the power socket.

FIG.1.1 CONNECTION DIAGRAM

SPECIFICATIONS:
DVI interface type ………………………………………………………………….DVI-D 29-pin, female
Single link input/output resolution …………………………………………up to 4096×2160@30Hz
Max signal bandwidth………………….………………………………………………..340MHz
Max baud rate…………………….………………………….………………3.4Gbps Serial Link
Input/Output TMDS signal ………….……………………….…..……….0.5~1.5Volts p-p(TTL)
Input/Output DDC signal …………………………..……….…………………. 5Volts p-p (TTL)
Max working current ……………………………….………………………… …………1.2A/5V
Power adapter …………………………………………AC 100V～240V 50HZ/60Hz, DC5V/2A
Operating Temperature range …………..……………………………………………. -5 to +45℃
Storage Temperature range…………………………………………………………. -15 to +55℃
Operating Humidity range ………………….……….…..…….10 to 90%RH (No Condensation)
Storage Humidity range………………………….………………5 to 95%RH (No Condensation)
Notes:
Pls use the machine as the instruction listed to keep the long use lifetime of the machine.
1.The machine should be placed at the spot far from the Damp, High-Temperature, Dusty, Erosive, and oxidative environment.
2.All parts will be free from the strong shake, hit, fall.
3.Touching the power adaptor with the wet hands is prohibited.
4.Pls hold the power adaptor head and do not pull the power cord when cut off from the socket.
5.Pls turn the power off when the machines not used for long time.
6.Pls do not open the cover and do not touch the inside parts.
7.Pls use the original factory power adaptor.
FAQ:
Before power on, pls check the connection line carefully. And make sure that all interfaces are normally connected. The common trouble shooting way shows below: